Tools Required

1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
2. Remove the rear propeller shaft. Refer to One-Piece Propeller Shaft Replacement or Two-Piece Propeller Shaft Replacement in Propeller Shaft.
3. Remove the transmission. Refer to Transmission Replacement .



4. Remove the 6 bolts holding the quill tube to the front of the transmission.
5. Remove the quill tube.



6. Using the J 23907  (1) and the J 45278  (2), remove the input shaft seal.

Important: When installing the input shaft seal, there is not a stop for the seal in the case. Using the seal tools will install the seal at the proper depth. Hitting too hard on the seal tools can misplace the seal at the proper depth.

1. Using the J 22828 and the J 45277 , install the input shaft seal.

1.1.	Position the seal in the front case with the open side to the transmission.

1.2.	Lightly tap on the J 22828 to install the seal.




2. Install the quill tube.
3. Install the 6 bolts holding the quill tube to the front of the transmission.

Tighten
Tighten the quill tube bolts to 23 N·m (17 lb ft).

4. Install the transmission drain plug and O-ring seal. Ensure the O-ring seal is not damaged.

Tighten
Tighten the drain plug to 35 N·m (26 lb ft).

5. Install the transmission. Refer to Transmission Replacement .
6. Install the rear propeller shaft. Refer to One-Piece Propeller Shaft Replacement or Two-Piece Propeller Shaft Replacement in Propeller Shaft.
7. Check the transmission fluid level. Add if necessary.
8. Lower the vehicle.