Removal Procedure
- Remove the engine cover. Refer to 
Engine Cover Replacement 
 in Interior
Trim.
 
- Remove the air cleaner layer. Refer to 
Air Cleaner Replacement 
.
 
- Relieve the fuel system pressure. Refer to 
Fuel Pressure Relief 
 .
 
- Disconnect the fuel pressure regulator vacuum line (1).
 
- Clean any dirt from the fuel pressure regulator retainer and the surrounding
area.
 
- Remove the fuel pressure regulator retainer (9).
 
- Remove the fuel pressure regulator (8) from the fuel pressure regulator
housing.
 
Installation Procedure
- Install the backup ring (10) on the fuel pressure
regulator (8).
 
- Install the new large O-ring (11) on the fuel pressure regulator.
 
- Install the regulator filter (12) on the fuel pressure regulator.
 
- Install the new small O-ring (13) on the fuel pressure regulator.
 
- Lubricate the fuel pressure regulator large O-ring and the small O-ring
with clean engine oil.
 
- Push the fuel pressure regulator into the regulator housing on the fuel
rail.
 
- Install a new fuel pressure regulator retainer (9).
 
- Connect the fuel pressure regulator vacuum line (1).
 
- Connect the negative battery cable.
 
- Tighten the fuel filler cap.
 
- Inspect for leaks.
 
| 11.1.  | Turn ON the ignition for 2 seconds. | 
 
| 11.2.  | Turn OFF the ignition for 10 seconds. | 
 
| 11.3.  | Turn ON the ignition. | 
 
| 11.4.  | Inspect for fuel leaks. | 
 
- Install the air cleaner layer. Refer to 
Air Cleaner Replacement 
.
 
- Install the engine cover. Refer to 
Engine Cover Replacement 
 in
Interior Trim.