Removal Procedure
- Drain the reservoir.
 
Important: Cap the hoses in order to prevent dirt from entering the system.
- Remove the hoses from the reservoir. 
 
- Remove nuts holding the reservoir.
 
- Remove the reservoir.
 
Installation Procedure
- Install the reservoir to the vehicle. 
 
Notice: Refer to Fastener Notice in the Preface section.
- Install the washers and the nuts.
 
Tighten
Tighten the reservoir mounting nuts to 28 N·m (21 lb ft). 
- Connect the hoses to the reservoir.
 
- Bleed the system. Refer to 
Power Steering System Bleeding
 .