Tools Required

1. Remove the back-up lamp switch.



2. Remove the reverse gear idler shaft bracket bolt with the O-ring seal.
3. Remove and discard the O-ring seal.



4. Remove the reverse gear idler shaft bracket. Rotate the bracket to aid in removal.



5. Remove the reverse gear idler shaft.
6. Remove the reverse idler gear bearings.
7. Remove the reverse idler gear.



8. If RWD, remove the mainshaft rear oil seal and discard.



9. If 4WD, remove the mainshaft rear bearing O-ring seal and discard.




Important: Only remove the bearings if replacing the bearings. Do not use the bearings again after removal.

10. Inspect the bearings for damage or wear. Refer to Bearings and Spacers Cleaning and Inspection .
11. Remove the rear case shift rail bearing using the J 44707  (1) and the J 44737  (2). Expand the J 44737 to fit securely in the bearing.




Important: Only remove the bearings if replacing the bearings. Do not use the bearings again after removal.

12. Inspect the bearings for damage or wear. Refer to Bearings and Spacers Cleaning and Inspection .
13. Remove the countershaft rear bearing from the rear case using the J 44736  (1) and the J 44738  (2). Expand the J 44738 to fit securely in the bearing.

Tools Required

Notice:  Do not nick, scratch or damage the sealing surface. The sealing surface is a machined surface. Damage to the machined surface can cause leakage.

1. Remove the back up lamp switch.



2. Remove the bolt with the O-ring seal for the reverse gear idler shaft bracket.
3. Remove and discard the O-ring seal.



4. Remove the reverse gear idler shaft bracket. Rotate the bracket to aid in removal.



5. Remove the reverse gear idler shaft.
6. Remove the reverse idler gear bearings.
7. Remove the reverse idler gear.



8. Remove the mainshaft rear oil seal and discard.




Important: Only remove the bearings if you are replacing the bearings. Do not use the bearings again after removal.

9. Inspect the bearings for damage or wear. Refer to Bearings and Spacers Cleaning and Inspection .
10. Using the J 44707  (1) and the J 44737  (2), remove the rear case shift rail bearing. Expand the J 44737 to fit securely in the bearing.




Important: Only remove the bearings if you are replacing the bearings. Do not use the bearings again after removal.

11. Inspect the bearings for damage or wear. Refer to Bearings and Spacers Cleaning and Inspection .
12. Using the J 44736  (1) and the J 44738  (2), remove the countershaft rear bearing from the rear case. Expand the J 44738 to fit securely in the bearing.