Tools Required

Caution: If a window is cracked but still intact, crisscross the window with masking tape in order to reduce the risk of damage or personal injury.

Important: Before cutting out a window, apply a double layer of masking tape around the perimeter of the painted surfaces and interior trim.

1. Remove the window lower garnish molding, if equipped. Refer to Rear Window Garnish Molding Replacement in Interior Trim.

Caution: If broken glass falls into the defroster outlets, it can be blown into the passenger compartment and cause personal injury.

2. Cover to protect the following parts from broken glass:

•	Upper dash pad

•	Defroster outlets and A/C outlets

•	Seats and carpeting

3. Pull upward on the seat bottom of the passenger 60/40 seat.
4. Set the assist rod into position.
5. Remove the 4 bolts that hold the passenger seat back to the seat base.
6. Fold the back of the seat down.
7. Fold the center seat down.
8. Fold the left side seat back downward, and slide the seat fully forward.




Caution: When working with any type of glass or sheet metal with exposed or rough edges, wear approved safety glasses and gloves in order to reduce the chance of personal injury.

Important: Keep the cutting edge of the tool against the window.

9. This will allow the urethane adhesive to be separated from the window.

•	Leave a base of urethane on the pinchweld flange.

•	The only suitable lubrication is clear water.

•	UseJ 24402-A , J 39040 or equivalent in order to remove the window.

10. Open the sliding window, if equipped.



11. With the aid of an assistant, remove the window from the opening.

Important: When installing rear windows, install from the inside of the vehicle.

1. With the aid of an assistant, install the rear window into the opening. Refer to Adhesive Installation of Stationary Windows .
2. Install the window lower garnish molding, if equipped. Refer to Rear Window Garnish Molding Replacement in Interior Trim.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Install the 4 bolts that hold the passenger seat back to the seat base.

Tighten
Tighten the bolts to 18 N·m (13 lb ft).

4. Remove the assist rod.
5. Lower the seat bottom of the passenger 60/40 seat.
6. Raise the rear seat backs to their upright position.
7. Remove the double layer of masking tape around the perimeter of the painted surfaces and interior trim.