For 1990-2009 cars only
Removal Procedure
- Carefully push the outside rearview mirror face on the inner edge (near the front door window glass) to allow finger access.
- Grasp the mirror face firmly and pull it from the mirror body.
- Remove the outside rearview mirror case from the outside rearview mirror housing and disconnect the heater wire (if equipped).
- Remove the two jackscrews from back of the mirror case
Caution: When working with any type of glass or sheet metal with exposed or rough edges, wear approved safety glasses and gloves in order to reduce the chance of personal injury.
| • | Bend the two jackscrews over. |
| • | Press down on the side of the jackscrew popping the screw from the mirror glass case. |
| • | Save the jackscrews for reinstallation to the mirror motor. |
Installation Procedure
- Push the jackscrews into the mirror motor.
- Rotate both jackscrews to position the ball flanges to be inline with the attaching hub. They will then be correctly positioned to the mirror face.
- Install the electric heater wire to the mirror, if equipped.
- Align the wire stabilizers (if equipped) on the mirror case to the motor. Also align the mirror case to the motor.
- With the palm of your gloved hand, press firmly on the center of the glass until the case seats onto the motor.
- With the palm of you gloved hand pivot the mirror face to engage the jackscrews.
- Check the mirror operation and clean the glass face.
Important: The jackscrew springs must be positioned on the fingers (opposite the ball end) to compress the fingers.
The jackscrews will give a clicking noise when properly seated.
