- Raise and support the vehicle.
 
- Remove the transaxle drain plug and allow the transaxle to drain completely. 
 
- Remove the fluid level check plug. 
 
Caution: Refer to Fastener Caution in the Preface section.
- Clean and install the transaxle drain plug and tighten to 
6 N·m (53 lb in), plus an additional 45-180 degrees.
 
- Add SAE75W90 transaxle fluid until it seeps out of the fluid level check plug.
 
- Clean and install the fluid level check plug and tighten to 
 6 N·m (53 lb in), plus an additional 45-180 degrees.
 
- Lower the vehicle and verify proper operation.
 
Fluid Specification 
 | SAE75W90 
 | 
Fluid Capacity 
 | FWD 
 | 2.1L (2.22 qt) 
 |