Replacing the body control module (BCM) may be necessary when you service the body control system.

1. Remove the left instrument panel sound insulator from the vehicle. Refer to Instrument Panel Insulator Panel Replacement - Left Side in Instrument Panel, Gauges and Console.
2. Remove the center instrument panel sound insulator from the vehicle. Refer to Closeout/Insulator Panel Replacement - Center in Instrument Panel, Gauges and Console.
3. Disconnect the electrical connectors from the body control module.
4. Bend the 2 snap retainers back slightly and pull the body control module from the bracket at an angle.

1. Install the body control module to the bracket at an angle under the wide hook retainer, with the label facing away from the bracket.
2. Apply pressure on the left side of the body control module in order to move the module toward the mounting bracket base. Snap the module into place.
3. Ensure that the module is fully seated. Ensure that both snap retainers are holding the module.
4. Connect the electrical connectors to the body control module.
5. Install the center instrument panel sound insulator to the vehicle. Refer to Closeout/Insulator Panel Replacement - Center in Instrument Panel, Gauges and Console.
6. Install the left instrument panel sound insulator to the vehicle. Refer to Instrument Panel Insulator Panel Replacement - Left Side in Instrument Panel, Gauges and Console.
7. Use the following components in order to program the body control module with the proper calibrations:

•	The Techline Terminal

•	The scan tool

8. Perform the Learn Procedure.
9. Clear the diagnostic trouble codes (DTCs).