Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
1 | Did you review the Wiper/Washer System Description and Operation and perform the necessary inspections? | -- | Go to Step 2 | Go to Symptoms |
2 | Does the rear washer pump operate? | -- | Go to Step 3 | Go to Rear Washer Inoperative |
3 | Check for an open RR W/W fuse in the Underhood Fuse Block. Was an open fuse found? | -- | Go to Step 4 | Go to Step 5 |
4 | Replace the open fuse. Is the replacement complete? | -- | Go to Step 18 | -- |
5 |
Is the test light on? | -- | Go to Step 7 | Go to Step 6 |
6 | Repair the open in CKT 1240. Is the repair complete? | -- | Go to Step 18 | -- |
7 |
Is the test light on? | -- | Go to Step 8 | Go to Step 11 |
8 | Connect a J 35616-200 from the rear wiper motor harness, terminal C to terminal A. Is the test light on? | -- | Go to Step 10 | Go to Step 9 |
9 | Repair the open in CKT 1350. Is the repair complete? | -- | Go to Step 18 | -- |
10 | Replace the rear wiper motor. Refer to Rear Window Wiper Motor Replacement Is the replacement complete? | -- | Go to Step 18 | -- |
11 |
Is the test light on? | -- | Go to Step 12 | Go to Step 15 |
12 |
Is there continuity? | -- | Go to Step 13 | Go to Step 14 |
13 | Repair the open in CKT 393. Is the repair complete? | -- | Go to Step 18 | -- |
14 | Replace the rear window wiper cutout switch. Is the replacement complete? | -- | Go to Step 18 | -- |
15 | Backprobe from the rear wiper/washer switch connector, terminal C, to ground using a J 35616-200 . Is the test light on? | -- | Go to Step 16 | Go to Step 17 |
16 | Repair the open in CKT 391. Is the repair complete? | -- | Go to Step 18 | -- |
17 | Replace the rear wiper/washer switch. Is the replacement complete? | -- | Go to Step 18 | -- |
18 | Operate the system in order to verify the repair. Did you correct the condition? | -- | System OK | Go to Symptoms |
