GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2007 🢒 Silverado Classic - 2WD 🢒 HVAC 🢒 Heating, Ventilation, and Air Conditioning 🢒 Odor Diagnosis

Step

Action

Yes

No

1

Were you sent here from Symptoms or another diagnostic table?

Go to Step 2

Go to Symptoms - HVAC Systems - Manual

or

Go to Symptoms - HVAC Systems - Automatic

2
  1. Sit inside the vehicle.
  2. Close all of the doors and windows.
  3. Start the engine.
  4. Allow the engine to idle at normal operating temperature.
  5. Select the maximum blower speed.
  6. Select the VENT mode.
  7. Select the coldest temperature setting.
  8. Cycle through all of the blower speeds, modes, and temperatures to define what type of odor is present.
    9. • Musty smell
    • Coolant smell
    • Oil smell

Does the odor have a musty smell?

Go to Step 3

Go to Step 8

3

Inspect the HVAC air inlet grille for debris.

Is debris present?

Go to Step 4

Go to Step 5

4

Remove any debris.

Is the action complete?

Go to Step 15

--

5

Inspect for wet carpeting.

Is the carpet wet?

Go to Step 6

Go to Step 14

6

Inspect for the following conditions:

    • Water leaks around the windshield
    • Blockage of the HVAC module drain
    • Leaks around the door seals

Is a leak present?

Go to Step 7

Go to Step 14

7

Repair the leak as necessary.

Is the repair complete?

Go to Step 15

--

8

Does the odor have a coolant smell?

Go to Step 9

Go to Step 12

9

Inspect the cooling system for leaks. Refer to Loss of Coolant .

Is a leak present in the engine compartment?

Go to Step 10

Go to Step 12

10

Inspect for coolant leaking inside the vehicle or for a film build-up on the windshield.

Is the condition present?

Go to Step 11

Go to Step 15

11

Replace the heater core. Refer to Heater Core Replacement .

Is the repair complete?

Go to Step 15

--

12

Does the odor have an oily smell?

Go to Step 13

Go to Step 15

13
  1. Inspect the engine compartment for any leaks. Refer to the following procedures:
    2. •  Oil Leak Diagnosis for the 4.3L engine
    •  Oil Leak Diagnosis for the 4.8L, 5.3L, and 6.0L engine
    •  Oil Leak Diagnosis for the 6.6L engine
    •  Oil Leak Diagnosis for the 8.1L engine
    •  Fluid Leak Diagnosis for the 4L60-E engine
    •  Fluid Leak Diagnosis for the 4L80-E engine
    •  Fluid Leak Diagnosis for the Allison transmission
  2. Repair any oil leaks.

Is the repair complete?

Go to Step 15

--

14

A musty odor can be caused by mold or mildew build-up on the evaporator or the heater core or inside of the HVAC module. Refer to Odor Correction .

Is the action complete?

Go to Step 15

--

15

Operate the system in order to verify the repair.

Did you find and correct the condition?

System OK

Go to Step 2