Removal Procedure
- Open the instrument panel
 (IP) compartment.
 
- Push in the left and right side of the IP compartment and lower
 the  IP compartment.
 
- Unsnap the A/C compressor
 control module (2) and slide towards the rear of the vehicle.
 
- Tilt the A/C compressor control module and disconnect the evaporator
 temperature sensor connector.
 
- Disconnect the A/C compressor control module connector.
 
- Remove the A/C compressor control module from the vehicle.
 
Installation Procedure
- Install the  A/C comparison
 control module (2) to the vehicle.
 
- Connect the A/C comparison control module  electrical connector.
 
- Tilt the  A/C compressor control module and connect the evaporator
 temperature sensor.
 
- Line up the  A/C comparison control module with the slots on the
 heater case and slide into place. Ensure that the  A/C comparison control
  module snaps into place.
 
- Close the instrument panel compartment.