Removal Procedure
- Remove the instrument panel (I/P) assembly.
Refer to 
Instrument Panel Assembly Replacement 
 in
Instrument Panel, Gages and Console.
 
- Remove the driver side air distributor duct screws.
 
- Remove the air distributor duct (1) from the I/P.
 
- Unclip the radio antenna wire from the duct
 
- Remove the air temperature sensor from the duct.
 
Installation Procedure
- Install the air distributor duct (1)
to I/P.
 
Notice: Refer to Fastener Notice in the Preface section.
- Install the retaining screws to the air distributor duct.
 
Tighten
Tighten the screws to 1.9 N·m (17 lb in).
- Install the air temperature sensor to the air distributor duct.
 
- Clip the radio antenna wire to the duct.
 
- Install the I/P assembly. Refer to 
Instrument Panel Assembly Replacement 
 in Instrument Panel, Gages and Console.