GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2007 🢒 TrailBlazer - 4WD 🢒 Body Systems 🢒 Lighting 🢒 Tail Lamp Replacement

Tail Lamp Replacement TrailBlazer

Removal Procedure

    Object Number: 718032 Size: SH
  1. Remove the 2 screws that retain the tail lamp assembly to the body.
  2. Pull the assembly directly rearward in order to release the 2 locking pins.
  3. Disconnect the tail lamp electrical connector.
  4. Remove the lamp assembly from the vehicle.
  5. Remove the tail lamp circuit board. Refer to Tail Lamp Circuit Board Replacement .

Installation Procedure

    Object Number: 718032 Size: SH
  1. Install the tail lamp circuit board. Refer to Tail Lamp Circuit Board Replacement .
  2. Connect the tail lamp electrical connector.
  3. Push the tail lamp assembly directly forward in order to seat the 2 locking pins.

    4. Notice: Refer to Fastener Notice in the Preface section.

  4. Install the 2 tail lamp assembly retaining screws.

    5. Tighten
    Tighten the screws to 1.9 N·m (17 lb in).

Tail Lamp Replacement Isuzu


Object Number: 1649338 Size: SF

Callout

Component Name

Notice: Refer to Fastener Notice in the Preface section.

Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .

Preliminary Procedure

Open the liftgate in order to access the rear tail lamp screws.

1

Tail Lamp Assembly Screws (Qty: 2)

Tip
Disconnect the electrical connector.

Tighten
1.9 N·m (17 lb in)

2

Locating Pins (Qty: 2)

3

Tail Lamp Lower Cover

4

Liftgate Upper Reveal Molding

Tip
Ensure the tail lamp upper edge is located under the liftgate reveal molding.

5

Filler Nuts (Qty: 2)

Tip
Inspect the filler nuts prior to installing the tail lamp screws.

6

Filler Retainers (Qty: 2)

Tip

    • Ensure the retainers are secure to the body panel prior to installation of the new tail light.
    • Transfer the circuit board to the new tail lamp. Refer to Tail Lamp Circuit Board Replacement .