Important: Before you perform the PSD re-initialization, check for Diagnostic Trouble
Codes (DTCs) by performing Diagnostic Mode 1.
Refer to Diagnostic Modes in
Power Sliding Door (PSD) Diagnostic Information
.
Perform the following PSD re-initialization procedure when any of the
following conditions occur:
| • | The PSD is inoperative. |
| • | Reconnecting the vehicle batteryd. |
| • | After recharging the vehicle battery. |
| • | After reinstalling or replacing the radio fuse located in the
underhood accessory wiring junction block. |
| • | Exiting any of the diagnostic modes. |
Perform this procedure in order to re-initialize the PSD:
- Set the PSD on/off switch in the overhead console to the off position.
- Manually open the PSD completely.
- Manually close and latch the PSD.
- Remove the RADIO fuse for 30 seconds.
- Reinstall the RADIO fuse.
- Wait 10 seconds.
- Set the PSD on/off switch in the overhead console to the on position.
- Press, then release either PSD open/close switch in order to completely
open the PSD.
- Wait 5 seconds.
- Press, then release either PSD open/close switch in order to allow
the PSD to close completely.
- Wait 5 seconds.
- Repeat steps 7 through 10 and re-check for proper PSD operation.
