Special Tools

J-28733-B Front Hub Spindle Remover

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation .



3. Disconnect the wheel speed sensor electrical connector (2).



4. Remove the wheel speed sensor electrical connector from the bracket.
5. Remove the brake caliper bracket with the brake caliper. Refer to Front Brake Caliper Bracket Replacement .
6. Remove the brake rotor. Refer to Front Brake Rotor Replacement .
7. Remove the wheel drive shaft nut.



8. Use three wheel nuts in order to attach the J-28733-B spindle remover to the wheel bearing/hub.
9. Use the J-28733-B spindle remover in order to push the wheel drive shaft out of the wheel bearing/hub.



10. Remove and DISCARD the wheel bearing/hub bolts.

Note: Ensure that the wheel drive shaft outer seal boot is not damaged.

11. Remove the wheel bearing/hub.

1. Install the wheel bearing/hub.

Caution: Refer to Fastener Caution in the Preface section.

Warning: These fasteners MUST be replaced with new fasteners anytime they become loose or are removed. Failure to replace these fasteners after they become loose or are removed may cause loss of vehicle control and personal injury.

2. Install NEW wheel bearing/hub bolts and tighten to 130 N·m (96 lb ft) .
3. Install the wheel drive shaft nut.
4. Install the brake rotor. Refer to Front Brake Rotor Replacement .
5. Install the brake caliper bracket with the brake caliper. Refer to Front Brake Caliper Bracket Replacement .




Note: Ensure that the connector clip engages the bracket properly.

6. Install the wheel speed sensor electrical connector to the bracket.



7. Connect the wheel speed sensor electrical connector (2).
8. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation .
9. Lower the vehicle.