1

Turn the ignition to RUN or ACC.

Important: The following results may be different if weight has been added to or removed from the vehicle.

After approximately 35-55 seconds, the air compressor runs for 3-5 seconds.

2

Add approximately 181 kg (400 lb) to the rear of the vehicle.

1. During (or 7-27 seconds after) the loading of the vehicle, the system exhausts for 1 second, then the compressor motor turns on.
2. Within 1 minute, the rear of the vehicle rises in order to level the vehicle.
3. The compressor turns off.

3

Remove the weight from the rear of the vehicle.

1. During (or 7-27 seconds after) the unloading of the vehicle, the system exhausts.
2. The rear of the vehicle lowers the vehicle.
3. The ALC system retains a minimum pressure of 55-97 kpa (8-14 psi).

The ALC system does not exhaust. The rear of the vehicle does not lower. Refer to Automatic Level Control System Does Not Vent to Lower Vehicle .

* Refer to the appropriate symptom diagnostic table for the applicable abnormal result.

1

1. Turn the ignition to RUN or ACC.
2. Press the inflator ON button.

The compressor runs for approximately 10 minutes, then the compressor turns off.

2

Press the inflator OFF button.

The compressor motor stops.

The compressor motor does not stop. Refer to Automatic Level Control Compressor Motor Always On .

3

Depress the inflator valve core.

During compressor operation, approximately 483 kpa (70 psi) of air pressure is available at the inflator valve.

No or low air pressure is available at the inflator valve. Refer to Automatic Level Control Inflator Fill Valve Inoperative .

* Refer to the appropriate symptom diagnostic table for the applicable abnormal result.