Preliminary Procedures

1. Open the rear liftgate.
2. Remove the interior liftgate garnish molding. Refer to Liftgate Garnish Molding Replacement .
3. Disconnect the center high mounted stop lamp electrical connector.

1

Rear Spoiler Nut (Qty: 5)

Notice: Refer to Fastener Notice in the Preface section.

Tighten
6 N·m (53 lb )

2

Integral Spoiler Clip (Qty: 4)

Procedure

1. Insert a flat-bladed tool into the access holes in the inner liftgate panel in order to release the clips while lifting up on the outside edges of the rear spoiler.
2. Release the integral clips from across the upper liftgate flange working from the outboard edge inward.

3

Rear Spoiler Assembly

Tip
Remove and transfer the high mounted stop lamp. Refer to High Mount Stop Lamp Replacement .