Removal Procedure
- Disconnect the engine wiring harness electrical connector (1) from the mass air flow (MAF)/intake
air temperature (IAT) sensor (2).
- Remove the MAF/IAT sensor screws (1).
- Remove the MAF/IAT sensor (2) from the air cleaner assembly.
Installation Procedure
Notice:
| ā¢ | Handle the MAF sensor carefully. |
| ā¢ | Do not drop the MAF sensor in order to prevent damage to the MAF
sensor. |
| ā¢ | Do not damage the screen located on the air inlet
end of the MAF. |
| ā¢ | Do not touch the sensing elements. |
| ā¢ | Do not allow solvents and lubricants to come in contact with the
sensing elements. |
| ā¢ | Use a small amount of a soap based solution in order to aid in
the installation. |
- Insert the MAF/IAT sensor (2) into the air cleaner assembly.
Notice: Refer to Fastener Notice in the Preface section.
- Install the MAF/IAT sensor screws (1).
Tighten
Tighten the screws to 1.5 NĀ·m (13 lb in).
- Connect the engine wiring harness electrical connector (1) to the MAF/IAT sensor (2).
