For 1990-2009 cars only
Circuit Description
A replacement electronic brake control module (EBCM) is supplied with generic software and must be programmed to match the specific vehicle application.
DTC Descriptor
This diagnostic procedure supports the following DTC:
DTC C0558 Calibration Data Not Programmed
Conditions for Running the DTC
The ignition is ON.
Conditions for Setting the DTC
The EBCM is not programmed with complete software.
Action Taken When the DTC Sets
| • | The EBCM disables the ABS/dynamic rear proportion (DRP)/vehicle stability enhancement system (VSES). |
| • | The ABS indicator turns ON. |
| • | The brake warning indicator turns ON. |
| • | The stability indicator turns ON. |
Conditions for Clearing the DTC
The DTC clears when software programming is complete.
Step | Action | Yes | No |
|---|---|---|---|
1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | |
2 | Perform the set-up procedure for the electronic brake control module (EBCM). Refer to Control Module References . Did you complete the action? | -- |
