Removal Procedure
- Relieve the fuel system pressure. Refer to the 
Fuel Pressure Relief 
 .
 
- Disconnect the fuel feed (1) and fuel return (2) pipes from
the fuel rail.
 
- Remove the retaining clip attaching screw (4).
 
- Remove the crossover fuel pipe retainer clip (5).
 
- Remove the fuel return pipe attaching screw (3) and the fuel return
pipe retainer (2).
 
- Remove the fuel return pipe (1).
 
- Remove and discard the fuel return pipe O-ring (6).
 
Installation Procedure
- Lubricate a NEW fuel return pipe O-ring (6)
with clean engine oil.
 
- Install the fuel return pipe O-ring (6) onto the fuel return pipe (1).
 
Notice: Refer to Fastener Notice in the Preface section.
- Install the fuel return pipe (1).
 
- Install the fuel return pipe retainer (2) and the fuel return pipe
attaching screw (3).
 
- Install the crossover fuel pipe retainer clip (5).
 
Important: When installing the retaining clip attaching screw for the crossover pipe, always
start the screw by hand. This will prevent consequent stripping of the threads in
the rail.
- Install the retaining clip attaching screw (4).
 
Tighten
- Tighten the crossover fuel pipe retainer clip attaching screw (4)
to 3.8 N·m(34 lb in).
 
- Tighten the fuel return pipe attaching screw (3) to 5 N·m
(44 lb in).
 
- Connect the fuel return (2) and the fuel
feed (1) pipes to the fuel rail.
 
- Tighten the fuel filler cap.
 
- Connect the negative battery cable. 
 
- Use the following procedure in order to inspect for leaks:
 
| 10.1.  | Turn ON the ignition, with the engine OFF, for 2 seconds. | 
 
| 10.2.  | Turn OFF the ignition for 10 seconds. | 
 
| 10.3.  | Turn ON the ignition, with the engine OFF. | 
 
| 10.4.  | Inspect for fuel leaks. |