For 1990-2009 cars only
Removal Procedure
- Release the park brake (5).
- Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
- Loosen the equalizer.
- Lower the vehicle.
- Remove the release handle cable and grommet from the park brake pedal assembly.
- Depress the locking tabs and remove the release handle from the instrument panel.
- Disconnect the electrical connector from the park brake switch.
- Remove the bolts (2).
- Disconnect the park brake cable (3) from the lever (1). The locating tab on the lever must be straightened to release the cable.
- Depress the locking tabs on the park brake cable housing and remove the cable housing from the pedal assembly.
- Remove the lever assembly from the vehicle.
Installation Procedure
- Install the park brake cable housing to the park brake pedal assembly. Ensure that the locking tabs secure the housing to the assembly.
- Connect the park brake cable (3) to the lever assembly. Bend the locating tab over the cable.
- Install the lever assembly to the vehicle.
- Install the bolts (2).
- Connect the connector to the park brake switch.
- Install the release handle to the instrument panel. Ensure the locking tabs secure the handle to the instrument panel.
- Install the release handle grommet and cable to the park brake pedal assembly.
- Adjust the park brake. Refer to Park Brake Adjustment .
Notice: Refer to Fastener Notice in the Preface section.
Tighten
Tighten the bolts to 25 N·m (18 lb ft).
