Removal Procedure
Caution: This vehicle is equipped with a Supplemental Inflatable Restraint (SIR) System. Failure to follow the correct procedure could cause the following conditions:
|    •  | Unnecessary SIR system repairs | 
 
In order to avoid the above conditions, observe the following guidelines:
|    •  | Refer to SIR Component Views in order to determine if you are performing service on or near the SIR components or the SIR wiring. | 
 
|    •  | If you are performing service on or near the SIR components or the SIR wiring, disable the SIR system. Refer to Disabling the SIR System. | 
 
- Disable the SIR system. Refer to 
SIR Disabling and Enabling 
in SIR.
 
- Remove the upper and lower trim covers. Refer to 
Steering Column Trim Covers Replacement 
.
 
- Disconnect the connector to the turn signal and multifunction
switch assembly (2).
 
- Remove the 2 pan head tapping screws (1) and (3)
from the turn signal and multifunction switch assembly (2).
 
- Remove the turn signal and multifunction switch assembly (2)
from the steering column tilt head assembly.
 
Installation Procedure
- Install the turn signal and multifunction
switch assembly (2).
 
Notice: Refer to Fastener Notice in the Preface section.
Important: Be sure that the electrical contact of the turn signal and multifunction
switch assembly (2) rests on the turn signal cancel cam assembly.
- Screw the 2 pan head tapping screws (1) and (3)
into the turn signal and multifunction assembly (2).
 
Tighten
| •  | Tighten the top pan head tapping screw (1) to 3 N·m
(30 lb in). | 
 
| •  | Tighten the side pan head tapping screw (3) to 7 N·m
(62 lb in). | 
 
- Connect the connector to the turn signal and multifunction switch
assembly.
 
- Install the upper and lower trim covers. Refer to 
Steering Column Trim Covers Replacement 
.
 
- Enable the SIR system. Refer to 
SIR Disabling and Enabling 
 in
SIR.