Removal Procedure
- Disconnect the auxiliary fluid pump wire harness (1) from the auxiliary fluid pump control module connector (2).
 
- Remove the auxiliary fluid pump wire harness (6) from the harness retainers (7).
 
- Raise and support the vehicle. Refer to 
Lifting and Jacking the Vehicle.
 
- Remove the auxiliary fluid pump wire harness clip nut (3).
 
- Place a suitable drain pan under the transmission auxiliary fluid pump.
 
- Remove the auxiliary fluid pump bolts (1).
 
Caution: Do not damage the case sealing surface when removing or installing the pump and motor assembly.
- Remove the auxiliary fluid pump (2).
 
Caution: The auxiliary fluid pump gasket is not re-usable. Use a NEW gasket when replacing or damage may occur.
- Remove the auxiliary fluid pump gasket (3).
 
Installation Procedure
Caution: The auxiliary fluid pump gasket is not re-usable. Use a NEW gasket when replacing or damage may occur.
- Install the auxiliary fluid pump gasket (3).
 
Caution: Do not damage the case sealing surface when removing or installing the pump and motor assembly.
- Install the auxiliary fluid pump (2).
 
Caution: Refer to Fastener Caution in the Preface section.
- Install the auxiliary fluid pump bolts (1).
 
Tighten
 Tighten the bolts to 9-13 N·m (80-115 lb in).
- Install the auxiliary fluid pump wire harness clip nut (3).
 
Tighten
 Tighten the nuts to 9 N·m (80 lb in).
- Lower the vehicle.
 
- Install the auxiliary fluid pump wire harness (6) to the harness retainers (7).
 
- Connect the auxiliary fluid pump wire harness (1) to the auxiliary fluid pump control module connector (2).
 
Caution: Use Dexron VI transmission fluid only. Failure to use the proper fluid may result in transmission internal damage.
- Fill the transmission with the proper amount of transmission fluid. Refer to 
Fluid Capacity Specifications and 
Transmission Fluid Check.