Removal Procedure
- Remove the ECU bracket.
 
- Remove the fuel supply hose (13).
 
- Remove the bolt (9) and nut (3).
 
- Remove the pipe retaining clips (10, 11).
 
- Remove the I bolt (2). Discard the washer.
 
- Remove the fuel supply pipe (1).
 
Installation Procedure
- Position the fuel supply pipe (1) and hand tighten the I bolt (2). Use a NEW washer on the I bolt.
 
- Install the fuel pipe clips (10, 11) to the fuel supply pipe (1).
 
Notice: Refer to Fastener Notice in the Preface section.
- Install the fuel supply pipe retaining bolt (9) and nut (3).
 
Tighten
|     •  | Tighten the I bolt to 17  N·m (13 lb ft). | 
 
|     •  | Tighten the fuel supply pipe retaining bolt and nut to 9  N·m (80 lb in). | 
 
- Install the fuel supply hose (13).
 
- Install the ECU bracket.
 
- Start the engine, and confirm fuel is not leaking from the connections.