Tools Required

Important: Torque converter size is model dependent.

1. Install an end play fixture adapter.

•	Use J 25022 for a 245 mm and 258 mm turbine shaft (1).

•	Use J 34725 for a 298 mm turbine shaft (2).

•	Use J 43205 for a 300 mm turbine shaft (3).




2. Install the J 24773-A .



3. Remove an oil pump retaining bolt.
4. Install J 25025-7A (or a 278 mm or 11 in bolt) and lock nut.
5. Install J 8001-3 .



6. Set the J 8001-3 to zero.
7. Pull up on J 24773-A .

Proper end play should be 0.13-0.92 mm (0.005-0.036 in).

8. The selective thrust washer (616), which controls the end play, is located between the input housing (621) and the thrust bearing (615) on the oil pump hub.

If the end play measurement is incorrect, refer to Torque Converter End Play Specifications. Choose a new selective thrust washer (616) based on the original selective washer and the information contained in the table.

If the dial indicator shows no end play, the selective thrust washer (616) and thrust bearing (615) may have been misassembled.

9. Correct the end play by changing the selective thrust washer (616).