Turn Signal Cancel Cam and Bearing Thrust Washer - Assemble - Off Vehicle Column Shift

Tools Required

J 23653-SIR Lock Plate Compressor

1. Lubricate the turn signal cancel cam assembly (3) with synthetic grease.
2. Install the following parts onto the steering shaft assembly:

•	The thrust washer (1)

•	The upper bearing spring (2)

•	The turn signal cancel cam assembly (3)

•	The shaft lock shield assembly (4)




3. Compress the shaft lock shield assembly (2) using J 23653-SIR .
4. Install the new bearing retainer (1) onto the steering shaft assembly.
5. Firmly seat the bearing retainer (1) into the groove on the steering shaft assembly.
6. Remove J 23653-SIR from the steering shaft assembly.
7. Install the SRS coil assembly. Refer to Inflatable Restraint Steering Wheel Module Coil Assemble - Off Vehicle .

Turn Signal Cancel Cam and Bearing Thrust Washer - Assemble - Off Vehicle Floor Shift

Tools Required

J 23653-SIR Lock Plate Compressor

1. Install the following parts onto the steering shaft assembly:

•	The thrust washer (1)

•	The upper bearing spring (2)

•	Lubricate the turn signal cancel cam assembly (3) with lithium grease

•	The turn signal cancel cam assembly (3)

•	The shaft lock shield assembly (4)




2. Compress the shaft lock shield assembly (2) using J 23653-SIR .
3. Install the new bearing retainer (1) onto the steering shaft assembly.
4. Firmly seat the bearing retainer (1) into the groove on the steering shaft assembly.
5. Remove J 23653-SIR from the steering shaft assembly.
6. Install the SRS coil assembly. Refer to Inflatable Restraint Steering Wheel Module Coil Assemble - Off Vehicle .