Step
| Action
| Value(s)
| Yes
| No
|
1
| Did you perform the Audible Warnings System Check?
| --
| Go to
Step 2
| Go to
Audible Warnings System Check
|
2
|
- Verify that the left front safety belt is unbuckled.
- Turn the ignition switch to the ON position.
- Both of the following events should occur:
| • | The FASTEN BELTS indicator is illuminated for approximately 70 seconds. |
| • | The chime sounds for approximately 6 seconds. |
Did both of the events occur?
| --
| Go to
Step 4
| Go to
Step 3
|
3
|
- Leave the left front safety belt unbuckled.
- Leave the ignition switch in the ON position.
Does only the chime sound?
| --
| Go to
Audible Warnings System Check
| Go to
Step 5
|
4
|
- Turn the ignition switch to the OFF position.
- Buckle the left front safety belt.
- Turn the ignition to the ON position.
- Both of the following events should occur:
| • | The FASTEN BELTS indicator illuminates. |
Did both of the events occur?
| --
| Go to
Step 7
| Go to
Audible Warnings System Check
|
5
|
- Leave the left front safety belt unbuckled.
- Leave the ignition switch in the ON position.
Does only the FASTEN BELTS indicator illuminate?
| --
| Go to
Step 6
| Go to
Step 7
|
6
| Inspect the body control module (MALL) connector C2
for proper contact.
Is the MALL connector contact OK?
| --
| Go to
Step 8
| Go to
Step 12
|
7
|
- Disconnect the MALL connector C2.
- Measure the resistance between the MALL connector C2 terminal D1
(harness side) and ground.
Is the resistance less than the specified value?
| 5 ohms
| Go to
Step 8
| Go to
Step 9
|
8
| Replace the MALL. Refer to
Body Control Module Replacement
in Body Control System.
Did you complete the repair?
| --
| Go to
Audible Warnings System Check
| --
|
9
| Inspect CKT 238 (BLK/WHT) for an open or a short
to ground.
Is there an open or a short to ground in CKT 238?
| --
| Go to
Step 13
| Go to
Step 10
|
10
| Inspect connector C301 for proper terminal contact.
Is connector C301 OK?
| --
| Go to
Step 11
| Go to
Step 12
|
11
|
| • | Verify that terminal A and terminal B of the safety
belt switch maintain continuity with the safety belt unbuckled. |
| • | Verify that terminal A and terminal B have no continuity
with the safety belt buckled. |
Is the safety belt switch OK?
| --
| Go to
Audible Warnings System Check
| --
|
12
| Repair the faulty connector. Refer to
Wiring Repairs
in Wiring Systems.
Did you complete the repair?
| --
| Go to
Audible Warnings System Check
| --
|
13
| Repair the open to the faulty CKT. Refer to
Wiring Repairs
in Wiring Systems.
Did you complete the repair?
| --
| Go to
Audible Warnings System Check
| --
|
