Step
| Action
| Value(s)
| Yes
| No
|
1
| Did you perform the Power Mirrors
System Check?
| --
| Go to
Step 2
| Go to
Outside Mirrors System Check
|
2
|
- Set the mirror select switch to the inoperative mirror.
- Use a J 39200
digital multimeter (DMM) in order to backprobe the power mirror switch between
terminal M and terminal E (left outside power mirror).
- Position the power mirror switch to the left and then to the right.
Is the voltage within the specified range?
| 10-15 V
| Go to
Step 3
| Go to
Step 7
|
3
|
- Disconnect the inoperative outside power mirror connector.
- Connect the DMM between terminal A and terminal B
of the outside power mirror connector.
- Position the power mirror switch to the left and then to the right.
Is the voltage within the specified range?
| 10-15 V
| Go to
Step 8
| Go to
Step 4
|
4
|
- Connect the DMM between the outside power mirror connector terminal B
and ground.
- Position the power mirror switch to the right direction.
Is the voltage within the specified range?
| 10-15 V
| Go to
Step 6
| Go to
Step 5
|
5
| Repair the open or the short to ground in the following
circuits. Refer to
Wiring Repairs
in Wiring Systems:
| • | CKT 81 (WHT) (left outside power mirror) |
| • | CKT 881 (RED/WHT) (right outside power mirror) |
Did you complete the repair?
| --
| Go to
Outside Mirrors System Check
| --
|
6
| Repair the open
or the short to ground in CKT 82 (LT BLU). Refer to
Wiring Repairs
in Wiring Systems.
Did you complete the repair?
| --
| Go to
Outside Mirrors System Check
| --
|
7
| Replace the power
mirror switch. Refer to
Power Mirror Switch Replacement
.
Did you complete the repair?
| --
| Go to
Outside Mirrors System Check
| --
|
8
| Replace the suspect
outside power mirror. Refer to
Power Mirror Replacement
.
Did you complete the repair?
| --
| Go to
Outside Mirrors System Check
| --
|
