Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
1 | Did you review the Wiper/Washer System Description and Operation and perform the necessary inspections? | -- | Go to Step 2 | Go to Symptoms |
2 |
Do the wipers park? | -- | Go to Step 3 | Go to Step 4 |
3 | Replace the wiper/washer switch. Refer to Multifunction, Turn Signal, and Hazard Switch Replacement - On Vehicle in Steering Wheel and Column - Standard or Multifunction, Turn Signal, and Hazard Switch Replacement - On Vehicle in Steering Wheel and Column - Tilt. Is the replacement complete? | -- | Go to Step 13 | -- |
4 | Measure the voltage from connector C211 (vehicle side), terminal E8, to ground using a J 39200 . Is the measurement greater than the specified value? | 1.0 V | Go to Step 10 | Go to Step 5 |
5 | Measure the voltage from connector C211 (vehicle side), terminal E5, to ground using a J 39200 . Is the measurement greater than the specified value? | 1.0 V | Go to Step 7 | Go to Step 6 |
6 | Replace the wiper motor module. Refer to Windshield Wiper System Module Replacement . Is the replacement complete? | -- | Go to Step 13 | -- |
7 |
Is the measurement greater than the specified value? | 1.0 V | Go to Step 9 | Go to Step 8 |
8 | Replace the wiper motor module. Refer to Windshield Wiper System Module Replacement . Is the replacement complete? | -- | Go to Step 13 | -- |
9 | Repair the short to voltage condition in CKT 112. Is the repair complete? | -- | Go to Step 13 | -- |
10 |
Is the measurement greater than the specified value? | 1.0 V | Go to Step 12 | Go to Step 11 |
11 | Replace the wiper motor module. Refer to Windshield Wiper System Module Replacement . Is the replacement complete? | -- | Go to Step 13 | -- |
12 | Repair the short to voltage condition in CKT 113. Is the repair complete? | -- | Go to Step 13 | -- |
13 | Operate the system in order to verify the repair. Did you correct the condition? | -- | System OK | Go to Symptoms |
