DEFINITION: Improper air delivery.

Were you sent here from Symptoms or another diagnostic table?

Go to Step 2

Go to Symptoms - HVAC Systems - Manual

1. Start the engine.
2. Turn the blower motor fan ON and select an air outlet mode.

Does air flow out of the selected HVAC outlet ducts?

Go to Step 4

Go to Step 3

Did the customer concern mention that the air discharges out the correct ducts at first, but then changes during higher engine RPM?

Go to Step 8

Go to Step 4

With the engine running, cycle the HVAC controls through all the modes.

Does the air come out of the selected outlet ducts?

Go to Step 19

Go to Step 5

With the engine running, take a vacuum reading at the manifold vacuum port that supplies vacuum to the HVAC vacuum control assembly.

Is there engine vacuum?

Go to Step 7

Go to Step 6

Repair the no vacuum condition.

Is the repair complete?

Go to Step 19

--

Take a vacuum reading at the vacuum supply line at the HVAC vacuum control assembly.

Is the vacuum reading the same as the engine vacuum?

Go to Step 12

Go to Step 9

1. Disconnect the vacuum supply line from the HVAC vacuum control assembly.
2. With the vacuum gauge connected to the vacuum supply line, re-start the engine and turn the engine OFF.

Does the system lose vacuum after turning OFF the engine?

Go to Step 9

Go to Step 12

Inspect for leaking or collapsed vacuum lines between the engine manifold vacuum port and the HVAC vacuum control assembly.

Are the vacuum lines leaking?

Go to Step 10

Go to Step 11

Repair or replace the collapsed or leaking vacuum line.

Is the repair complete?

Go to Step 19

--

Replace the vacuum reservoir tank. Refer to Vacuum Tank Replacement .

Is the repair complete?

Go to Step 19

--

Using an external vacuum source, apply vacuum to the appropriate vacuum line at the connector to the HVAC vacuum control assembly. Refer to HVAC Schematics .

Does the actuator retract?

Go to Step 18

Go to Step 13

Inspect for leaking or collapsed vacuum lines between the actuator and the connector to the HVAC vacuum control assembly.

Are the vacuum lines leaking?

Go to Step 10

Go to Step 14

1. Disconnect the vacuum line from the actuator.
2. Apply an external vacuum source to the actuator.

Did the actuator retract?

Go to Step 15

Go to Step 17

With the actuator disconnected, inspect the door for binding.

Does the door move freely?

Go to Step 17

Go to Step 16

Repair the binding door. Refer to the appropriate repair.

Is the repair complete?

Go to Step 19

--

Replace the vacuum actuator. Refer to the appropriate repair.

Is the repair complete?

Go to Step 19

--

Replace the HVAC vacuum control assembly. Refer to Heater and Air Conditioning Control Replacement .

Is the repair complete?

Go to Step 19

--

Cycle the HVAC controls through all modes to verify proper operation.

Did you find and correct the condition?

System OK

Go to Step 2