1. Turn the ignition ON.
2. Connect pins 3 and 4 of DLC connector to enter diagnostics.
3. Check and record the codes.
4. Exit diagnostics.
5. Clear error codes. Refer to Clearing DTCs
6. Enter Diagnostics.

Are any error codes present?

--

Go to Step 2

Go to the appropriate diagnosis chart and Intermittents and Poor Connections

Is there a single code set?

--

Go to the appropriate error code diagnosis chart.

Go to Step 3

1. Disconnect the control module.
2. Check the resistance from drive to ground on each strut.

•	LF strut - pin D13 to pin D10

•	RF strut - pin C13 to pin D8

•	LR strut - pin D14 to pin D11

•	RR strut - pin C14 to pin D9

•	Resistance values should be between 20ohms and 60ohms

Does the resistance value on each strut match the resistance values of the other struts?

ohms

Go to Step 1

Go to Step 4

Check the connector and strut cavity of the unmatching strut for the following:

Are strut cavities and connectors free from moisture and dirt and connected properly?

--

Go to Step 1

Go to Step 5

1. Clean and dry the connector and strut cavity.
2. Reconnect the connector to the strut.

Are strut cavities and connectors free from moisture and dirt and connected properly?

--

Go to Step 1

--