For 1990-2009 cars only
Removal Procedure
Important:
• Be sure to dry fit the windshield reveal molding to
the windshield then as an assembly on the body prior to actual installation. • When replacing the windshield, the original windshield reveal
molding cannot be reused and must be replaced with a new windshield reveal
molding. • New windshield reveal moldings are primed and will adhere to the
urethane adhesive. • A heat lamp may be used to make the windshield reveal molding
more pliable. • The windshield reveal molding cannot be replaced without removing
the windshield.
- Using a flat-bladed tool, carefully pry the end of the windshield reveal molding out about 75 mm (3 inches).
- Grasp the windshield reveal molding and slowly pull the windshield reveal molding away from the body.
- Remove the windshield. Refer to Windshield Replacement .
Installation Procedure
- Starting from the center of the windshield hand press the reveal molding into place on the windshield.
- Dry fit the windshield, with the reveal molding installed, to the body prior to actual installation.
- Install the windshield. Refer to Windshield Replacement .
Tape the windshield reveal molding to keep it flush with the windshield if necessary.
