Tools Required

J 34730 , Fuel Pressure Gauge

Important: Always maintain cleanliness when servicing fuel system components.

1. Relieve fuel system pressure. Refer to Fuel Pressure Relief .
2. Remove the fuel sender assembly. Refer to Fuel Sender Assembly Replacement .
3. Note strainer (3) position for future reference.



4. Support the reservoir with one hand and grasp the strainer with the other hand.
5. Use a screwdriver to pry the strainer ferrule off the reservoir.
6. Discard the strainer.

1. Install the new strainer (4) to the reservoir.
2. Support the reservoir with one hand and grasp the strainer with the other hand twisting the strainer into position.
3. Install the fuel sender assembly. Refer to Fuel Sender Assembly Replacement .
4. Inspect for fuel leaks:
5. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .

5.1.	Turn the ignition switch to the ON position for two seconds.

5.2.	Turn the ignition switch to the OFF position for ten seconds.

5.3.	Turn the ignition switch to the ON position.

5.4.	Visually inspect the fuel system for fuel leaks.

6. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement .