Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
1 | Was the Wiper/Washer System Check performed? | -- | Go to Step 2 | |
2 |
Does the wiper keep running? | -- | Go to Step 6 | Go to Step 3 |
3 | Check for a short to voltage in the pigtail wires to the wiper/washer switch. Is a short to voltage present? | -- | Go to Step 5 | Go to Step 4 |
4 | Replace the wiper/washer switch. Refer to Multifunction, Turn Signal, and Hazard Switch Replacement - On Vehicle . Is the replacement complete? | -- | -- | |
5 | Repair the short to voltage in the pigtail wires to the wiper/washer switch. Is the repair complete? | -- | -- | |
6 | Measure the voltage from connector C201 (vehicle side), terminal E2, to ground with a DMM. Is the measurement greater than the specified value? | 1.0 V | Go to Step 14 | Go to Step 7 |
7 | Measure the voltage from connector C201 (vehicle side), terminal E3, to ground with a DMM. Is the measurement greater than the specified value? | 1.0 V | Go to Step 11 | Go to Step 8 |
8 |
Is the measurement within the specified range? | 10.5-15 V | Go to Step 9 | Go to Step 10 |
9 | Repair the short to voltage in CKT 92. Is the repair complete? | -- | -- | |
10 | Replace the wiper motor cover. Refer to Wiper Motor Cover Replacement . Is the replacement complete? | -- | -- | |
11 |
Is measurement greater than the specified value? | 1.0 V | Go to Step 12 | Go to Step 13 |
12 | Repair the short circuit to battery voltage condition in CKT 112. Is the repair complete? | -- | -- | |
13 | Replace the wiper motor cover. Refer to Wiper Motor Cover Replacement . Is the replacement complete? | -- | -- | |
14 |
Is the measurement greater than the specified value? | 1.0 V | Go to Step 16 | Go to Step 15 |
15 | Replace the wiper motor cover. Refer to Wiper Motor Cover Replacement . Is the replacement complete? | -- | -- | |
16 | Repair the short to voltage in CKT 113. Is the repair complete? | -- | -- |
