Did you perform the Instrument Cluster Diagnostic System Check?

--

Go to Step 2

Go to Diagnostic System Check - Instrument Cluster

1. Install a scan tool.
2. Turn ON the ignition, with the engine OFF.
3. With a scan tool, observe the Battery Voltage parameter in the IPC data list.

Does the scan tool reading for battery voltage fall within the range identified on the volt gauge?

--

Go to Charging System Test in Engine Electrical

Go to Step 3

Replace the instrument panel cluster. Refer to Instrument Cluster Replacement

Did you complete the repair?

--

Go to Step 4

--

Operate the system in order to verify the repair.

Did you correct the condition?

--

System OK

Go to Step 2