Tools Required

J 39400-A Halogen Leak Detector

Important: Refrigerant recovery is not required.




1. Remove the refrigerant pressure sensor wire harness connector.
2. Remove the refrigerant pressure sensor.
3. Remove and discard the O-ring.

1. Install a new O-ring. Refer to O-Ring Replacement .

Notice: Refer to Fastener Notice in the Preface section.

2. Install the refrigerant pressure sensor.

Tighten
Tighten to 5 N·m (44 lb in).




3. Install the refrigerant pressure sensor wire harness connector.
4. Leak test the fittings using the J 39400-A .