Important: Clean the evaporative emission (EVAP) connections and surrounding areas prior to disconnecting the line in order the avoid possible system contamination.

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Disconnect the EVAP vent valve electrical connector (1).
3. Remove the EVAP vent valve bracket bolt (3).
4. Remove the vent hose (4) from the EVAP vent valve.
5. Remove the EVAP vent valve from the bracket (2).

1. Install the EVAP vent valve to the bracket (2).
2. Install the vent hose (4) to the EVAP vent valve.
3. Install the EVAP vent valve and the bracket.

Notice: Refer to Fastener Notice in the Preface section.

4. Install the EVAP vent valve bracket bolt (3).

Tighten
Tighten the bolt to 10 N·m (89 lb in).

5. Connect the EVAP vent valve electrical connector (1).
6. Lower the vehicle.