Front Side Door Trim Panel Replacement Pontiac

Tools Required

J 38778 Door Trim Pad Clip Remover

1. Remove the manual window regulator handle from the front door, if equipped. Refer to Door Window Regulator Handle Replacement .
2. Remove the power door lock switch, if equipped. Refer to Door Lock Switch Replacement .
3. Remove the upper extension trim panel screw.
4. Remove the upper extension trim panel.



5. Remove the front door trim panel screws (3).
6. Remove the armrest screws (1).
7. Starting at the bottom of the door disengage the trim panel retainers using the J 38778 .
8. Lift up on the trim panel (2) to disengage the inner belt molding from the door flange.
9. Remove the door trim panel (2) from the inner door panel.
10. Disconnect the door speaker electrical connector.

1. Position the trim panel (2) to the inner door panel.
2. Connect the door speaker electrical connector.
3. Engage the inner belt molding over the door flange and press down.



4. Align the trim panel retainers to the inner door panel.

Press the trim panel (2) until the retainers are fully engaged.

Notice: Refer to Fastener Notice in the Preface section.

5. Install the door trim panel screws (3).

Tighten
Tighten the screws to 1.5 N·m (13 lb in).

6. Install the door armrest screws (1).

Tighten
Tighten the screws to 5.7 N·m (51 lb in).




7. Install the upper extension trim panel.
8. Install the upper extension trim panel screw.

Tighten
Tighten the screw to 1.3 N·m (12 lb in).

9. Install the power door lock switch, if equipped. Refer to Front Side Door Window Switch Replacement .
10. Install the window regulator handle to the door, if equipped. Refer to Door Window Regulator Handle Replacement .

Front Side Door Trim Panel Replacement Chevrolet

Tools Required

J 38778 Door Trim Pad Clip Remover

1. Remove the manual window regulator handle from the front door, if equipped. Refer to Door Window Regulator Handle Replacement .
2. Remove the power door lock switch, if equipped. Refer to Door Lock Switch Replacement .
3. Remove the upper extension trim panel screw.
4. Remove the upper extension trim panel.



5. Remove the door trim panel screws (3).
6. Remove the armrest screw (1).
7. Starting at the bottom of the door disengage the trim panel retainers using the J 38778 .
8. Lift up on the door trim panel (2) to disengage the inner belt molding from the door flange.
9. Remove the door trim panel (2) from the inner door panel.

1. Position the trim panel (2) to the inner door panel.
2. Engage the inner belt molding over the door flange and press down.



3. Align the door trim panel retainers to the inner door panel.

Press the trim panel (2) until the retainers are fully engaged.

Notice: Refer to Fastener Notice in the Preface section.

4. Install the door trim panel screws (3).

Tighten
Tighten the screws to 1.5 N·m (13 lb in).

5. Install the door armrest screw (1).

Tighten
Tighten the screw to 5.7 N·m (51 lb in).




6. Install the upper extension trim panel.
7. Install the upper extension trim panel screw.

Tighten
Tighten the screw to 1.3 N·m (12 lb in).

8. Install the power door lock switch, if equipped. Refer to Front Side Door Window Switch Replacement .
9. Install the window regulator handle to the door, if equipped. Refer to Door Window Regulator Handle Replacement .