Tools Required

J 36346 Fascia Retainer Remover

1. Remove the battery tray. Refer to Battery Tray Replacement .



2. Using the J 36346 , disconnect the shift control cable from the transaxle range switch lever.



3. Remove the transaxle range switch lever nut and lever.

Notice: Refer to Fastener Notice in the Preface section.




1. Install the transaxle range switch lever and lever nut.

Tighten
Tighten the nut to 16 N·m (12 lb ft).




2. Install the shift control cable end fitting onto the ball stud of the transaxle range switch lever. An audible snap will be heard when properly installed.
3. Install the battery tray. Refer to Battery Tray Replacement .