Special Tools

1. Remove the front wheel RH.
2. Remove the engine under cover RH.
3. Remove the engine cover. Refer to Engine Cover Replacement.
4. Remove the V-ribbed belt. Refer to Drive Belt Replacement.



5. Remove the crankshaft pulley.
6. Using the J-8614-A holder and remover , hold the pulley in place, loosen and remove the pulley bolt.



7. Place the J-21052-4 protector (1) on the end of the crankshaft



8. Using the J-8614-A holder and remover (1) , remove the crankshaft pulley.
9. Remove the timing chain cover oil seal.




Note: After removing, check the crankshaft for nicks or burrs. Smooth the surface with 400-grit sandpaper.

10. Using a knife, cut off the lip (1) of the oil seal.
11. Using a screwdriver with its tip wrapped with tape, pry out the oil seal.

1. Install the timing chain cover oil seal.
2. Apply MP grease to the lip of a new oil seal.




Note: Wipe off extra grease from the crankshaft.

3. Using J-41998-A installer  (1) and a hammer, tap in the oil seal until its surface is flush with the rear oil seal retainer edge.
4. Align the pulley set key with the key groove of the pulley.



5. Using the J-41665-1 installer (1), push the pulley onto the crankshaft.

Caution: Refer to Fastener Caution in the Preface section.




6. Using the J-8614-A holder and remover , hold the pulley in place and tighten the bolt to 190 N·m (140 lb ft).
7. Install the V-ribbed belt. Refer to Drive Belt Replacement.
8. Add the engine oil.
9. Inspect for engine oil leaks.
10. Install the engine cover. Refer to Engine Cover Replacement.
11. Install the engine under cover RH.
12. Install the front wheel RH.