Removal Procedure
Caution: Refer to Battery Disconnect Caution in the Preface section.
- Disconnect the negative battery cable.
 
- Recover the refrigerant. Refer to 
Refrigerant Recovery and Recharging
 .
 
- Remove the screw that secures the receiver-dryer band clamp.
 
- Remove the receiver-dryer with the bolts.
 
- Drain the oil from the receiver-dryer into a container. Measure the amount of oil drained from the receiver dryer and then discard this used oil.
 
Installation Procedure
Important: Do not uncap the new unit until just prior to installation.
- Add oil to the new receiver-dryer. Use the exact amount of oil that you drained from the receiver-dryer.
 
- Install new O-rings in the seal area recess of the new receiver-dryer.
 
- Install the receiver-dryer into the clamp position.
 
Notice: Refer to Fastener Notice in the Preface section.
- Install the connector block retaining bolt to the receiver-dryer.
 
Tighten
Tighten the receiver-dryer bolt to 14 N·m (10 lb ft).
- Install and tighten the band clamp bolt. 
 
- Connect the negative battery cable. 
 
- Evacuate and recharge the A/C system. Refer to 
Refrigerant Recovery and Recharging
 .