Notice: Refer to Fastener Notice in the Preface section.

Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .

Preliminary Procedures

1. Open the hood.
2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
3. Remove the wheelhouse panels from the left and right sides. Refer to Wheelhouse Panel Replacement .

1

Retainers, Panel Close Out Filler Hood (Qty: 2)

2

Screws, Panel Close Out Filler Hood (Qty: 2)

Tip
Filler close out panel is part of the fascia.

Tighten
2 N·m (18 lb in)

3

Screws, Extension Fascia Front (Qty: 5)

Tip
The screws are located across the bottom of the fascia extension.

Tighten
2 N·m (18 lb in)

4

Extension, Fascia Front

Tip
Pull forward to release the extension from the upper retainers.

5

Bezels, Fog Lamp (Qty: 2)

6

Retainer, Fascia Front Bumper Lower (Qty: 2)

Tip
One in each lower corner of the fascia.

7

Fascia, Front Bumper Upper

Tip
The fascia upper corners are retained by push snap retainers. Grabbing the inside corner of the fascia and pull forward to until fully released.

8

Bezel, Grille

Refer to Grille Replacement .

9

Fog Lamp Front

Refer to Front Fog Lamp Replacement .

10

Rivets, Bracket Lower Fascia (Qty: 4)

Tip
It will be necessary to drill out the rivets that attach the bracket to the fascia.

11

Brackets, Lower Fascia (Qty: 2)

Tip
Both lower corner

12

Rivets, Fascia Front Bumper Lower (Qty: 16)

Tip
It will be necessary to drill out rivets that attach the upper fascia to the lower fascia.

13

Fascia, Front Bumper Lower