For 1990-2009 cars only
Removal Procedure
- Access the coat hooks from the cargo area.
- If the vehicle is equipped with diversity antennas, remove the bolt and coat hook from the roof panel.
- If the vehicle is NOT equipped with diversity antennas, perform the following:
| 3.1. | Loosen the bolt retaining the coat hook to the roof panel. |
| 3.2. | Release the rear headliner push pins. |
| 3.3. | Lower the rear of the headliner far enough to access the plastic and metal washers. |
| 3.4. | Hold the metal washer from rotating and remove the bolt from the coat hook. |
| 3.5. | Remove the coat hook from the vehicle. |
Installation Procedure
- If the vehicle is NOT equipped with diversity antennas, perform the following:
- If the vehicle is equipped with diversity antennas, install the retaining bolt through the coat hook.
- Install the metal washer to the retaining bolt.
- Index the mounting hole on the antenna module grounding strap to the roof panel welded nut.
- Install the coat hook to the roof panel, positioning the open end of the coat hook inboard.
- Tighten the retaining bolt to 10 N·m (88 lb in).
| 1.1. | Install the bolt to the coat hook. |
| 1.2. | Install the bolt and coat hook assembly to the headliner. |
| 1.3. | Lower the rear of the headliner far enough to access the headliner substrate. |
| 1.4. | Install the plastic washer to the bolt. |
| 1.5. | Install the metal washer to the bolt. |
| 1.6. | Hold the metal washer from rotating and install the coat hook bolt to the metal washer. |
| 1.7. | Install the bolt retaining the coat hook to the roof panel. |
Caution: Refer to Fastener Caution in the Preface section.
| 1.8. | Tighten the retaining bolt to 10 N·m (88 lb in). |
| 1.9. | Install the rear headliner push pins. |
