Special Tools

KM-6625 Flywheel Locking Device

1. Open the hood.
2. Disconnect the battery.

•	Disconnect the negative connection from the ground terminal.

•	Loosen the nut.

3. Raise the vehicle by its full height.
4. Remove the drive belt tensioner. Refer to Drive Belt Tensioner Replacement .
5. Block the crankshaft.

Attach KM-6625 .

•	Detach the screwed connection (1).

•	Insert KM-6625 (2).

•	Tighten the screwed connection (3).




6. Remove the torsional vibration damper (1).

Remove the bolt (2).

7. Remove the front toothed belt cover (bottom) (3).

Remove the 4 bolts (4).

Notice: Refer to Fastener Notice in the Preface section.

1. Install the front toothed belt cover (lower).

Tighten
Tighten the 4 bolts to 6 N·m (53 lb in).

Important: The new bolt must be coated with screw locking compound (red).

2. Install the torsional vibration balancer.

Use a new bolt.

Tighten
Tighten the bolt to 95 N·m (70 lb ft) plus 30 degrees plus 15 degrees.

3. Remove KM-6625 .

•	Detach the screwed connection.

•	Tighten the bolted connection.

•	Use new nuts.

4. Lower the vehicle by its full height.
5. Install the drive belt tensioner. Refer to Drive Belt Tensioner Replacement .
6. Lower the vehicle by its full height.
7. Connect the battery.

Connect the negative connection to ground terminal.

Tighten
Tighten the nut to 5 N·m (44 lb in).

8. For programming procedures, refer to Control Module References .
9. Close the hood.