Removal Procedure
- Tilt the steering column in the upper position.
 
- Remove the light switch center.
 
| 2.1.  | Turn the light switch (1) to the left position and press in, then turn pressed switch to the middle position (3). | 
 
| 2.2.  | Remove the light switch center (2). | 
 
- Remove the inner paneling for the driver side knee bolster.
 
| 3.2.  | Disconnect and remove the driver knee bolster from the bracket. | 
 
Installation Procedure
- Install the inner paneling for the driver side knee bolster.
 
Notice: Refer to Fastener Notice in the Preface section.
- Install the driver knee bolster into the lower bracket.
 
Tighten
Tighten the 4 bolts to 2.5 N·m (22 lb in).
- Install the light switch center.
 
| 3.1.  | Connect and latch the wiring harness plug. | 
 
| 3.2.  | Insert the light switch center. | 
 
| 3.3.  | Turn the switch to the OFF position. | 
 
| 3.4.  | Tilt the steering column downwards. |