Removal Procedure
- Remove the steering wheel airbag module. Refer to Inflatable Restraint Steering Wheel Module Replacement .
- Connect the battery and switch on the ignition for vehicles with Open and Start.
- Lock the steering.
- Disconnect the wiring harness plug (1) for the horn.
- Remove the steering wheel from the steering column.
Important:
• Before installation work affecting the airbag, follow the safety instructions for the pyrotechnic systems. • The airbag unit must not be forced open and must always be laid with the cushion side facing upwards.
Important:
• Disregard for vehicles with Open and Start. • Switch off the ignition for vehicles with Open and Start. Open and close the driver door. The steering lock and ignition lock engage automatically.
| • | Turn the steering into the straight-ahead position. |
| • | Remove the ignition key. |
| • | Allow the steering lock to engage. |
| • | Remove the bolt (2). |
| • | Remove the steering wheel from the steering shaft. |
Installation Procedure
- Insert the steering wheel in the column integration module (CIM). The guide pin (1) on the back of the steering wheel must engage in the carrier (2) of the CIM.
- Guide the airbag (1) wiring harness through the opening in the steering wheel hub.
- Install the steering wheel to the steering shaft.
- Connect the wiring harness plug for the horn/infotainment.
- Install the steering wheel airbag module. Refer to Inflatable Restraint Steering Wheel Module Replacement .
- Connect the negative cable battery.
Important:
• During removal and installation, make sure that the markings (arrows) are in the positions illustrated. • The airbag contact unit must not be twisted.
Notice: Refer to Fastener Notice in the Preface section.
Important:
• Ensure that the marks (2) on the steering wheel and steering shaft align. • Clean the thread and install a new bolt with locking compound.
Position the steering wheel on the steering column.
Tighten
Tighten the bolt to 30 N·m (22 lb ft).
