Special Tools

KM-527-A Adjuster

1. Remove the front floor console. Refer to Front Floor Console Replacement .
2. Remove the battery. Refer to Battery Replacement .




Important: Do not remove the bolt.

3. Release the selector lever link.

Loosen the bolt (1) for relay point clamp.




4. Remove the transmission control lever assembly (1).

•	Remove the 4 bolts (2).

•	Pull out the transmission control lever assembly with selector lever link from the bulkhead.

1. Install the transmission control lever assembly (1).

Notice: Refer to Fastener Notice in the Preface section.

Important: Note selector lever link bellows in bulkhead.

2. Feed the transmission control lever assembly with selector lever link through the bulkhead.

Tighten
Tighten the 4 bolts (2) to 10 N·m (89 lb in).




3. Lock the transmission control lever in adjustment position.

•	Push the transmission control lever to the left.

•	Lock the transmission control lever and shift lever housing with KM-527-A (1).




4. Lock the selector lever link in the gearbox cover.

•	Turn the selector lever link counterclockwise.

•	Direction of 3rd gear.

•	Engage the locking pin (1) in the adjusting bore in the transmission cover (arrow).





Important: Do not change position of selector lever link.

5. Install the selector lever link.

Tighten
Tighten bolt  (1) to 12 N·m (106 lb in) plus 180-225 degrees.




6. Release the transmission control lever lock.

Detach KM-527-A (1)

Important: The locking pin in the adjusting bore hole releases automatically when first shifted in R direction. If necessary, release the locking pin by hand.

7. Release the locking pin in the transmission cover.
8. Inspect the ease of gear shifting.

•	With vehicle standing

•	With engine running

•	With clutch disengaged

9. Install the battery. Refer to Battery Replacement .
10. For programming procedures, refer to Control Module References .
11. Install the front floor console. Refer to Front Floor Console Replacement .