Special Tools

KM-962-A /KM-962-10 Tester

1. Remove the battery.

•	Disconnect the negative cable (2) from the battery.

Remove the nut.

•	Disconnect the positive cable (3) from the battery.

Remove the nut.

•	Remove the bracket (1).

Remove the bolt (4).

•	Remove the battery.




2. Remove the battery support.

•	Release the cable tie.

•	Remove the 3 bolts (1).

3. Connect KM-962-A  (3) to the wiring harness plug of the selector lever position switch

•	Disconnect the wiring harness plug of the selector lever position switch (1).

•	Open the locking shackle.

4. Connect KM-962-A with KM-962-A KM-962-10  (2) to the battery.
5. Inspect the setting of the selector lever position switch.

Note: The light diodes corresponding to the markings on the insert module (1) must flash for each individual gear.

•	Shift through all the gears one after the other.

•	If the setting is incorrect:

-	Adjust the selector cable. Refer to Range Selector Lever Cable Adjustment.

-	Adjust the selector lever position switch. Refer to Transmission Range Switch Adjustment.

-	Inspect the electrical function of the selector lever position switch.

-	See test instructions.

1. Connect the selector lever position switch wiring harness plug.

•	Disconnect KM-962-A from the selector lever position switch wiring harness plug.

•	Disconnect KM-962-A from KM-962-10.

•	Disconnect KM-962-A from the battery.

•	Lock the wiring harness plug.

Caution: Refer to Fastener Caution in the Preface section.




2. Install the battery support.

Fasten the cable tie.

Tighten
Tighten 3 bolts 10 N·m (89 lb in).




3. Install the battery.

•	Install the bracket (1).

•	Tighten the bolt (4).

Tighten
Tighten bolt 15 N·m (11 lb ft).

•	Connect the positive cable (3) to the battery.

•	Connect the negative cable (2) to the battery.

4. For programming procedures, refer to Control Module References.