Starter Replacement RPOs L61/LE5

1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
3. Remove the starter solenoid terminal nut (4).
4. Remove the positive battery cable terminal (3) from the starter.
5. Remove the starter solenoid "S" terminal nut (2).
6. Remove the engine harness terminals (1) from the starter.



7. Remove the starter bolts.
8. Remove the starter.

1. Position the starter to the engine.

Notice: Refer to Fastener Notice in the Preface section.

2. Install the starter bolts.

Tighten
Tighten the bolts to 40 N·m (30 lb ft).




3. Install the engine harness terminals (1) to the starter.
4. Install the starter solenoid "S" terminal nut (2).

Tighten
Tighten the nut to 3 N·m (27 lb in).

5. Install the positive battery cable terminal (3) to the starter.
6. Install the starter solenoid terminal nut (4).

Tighten
Tighten the nut to 17 N·m (13 lb ft).

7. Lower the vehicle.
8. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .

Starter Replacement RPO LSJ

1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
3. Remove the charge air cooler pump. Refer to Charge Air Cooler Coolant Pump Replacement .
4. Remove the starter solenoid terminal nut (4).
5. Remove the positive battery cable terminal (3) and the generator harness terminal (5) from the starter.
6. Remove the starter solenoid "S" terminal nut (1).
7. Remove the engine harness terminal (2) from the starter.



8. Remove the starter bolts.
9. Remove the starter.

1. Position the starter to the engine.

Notice: Refer to Fastener Notice in the Preface section.

2. Install the starter bolts.

Tighten
Tighten the bolts to 50 N·m (37 lb ft).




3. Install the engine harness terminal (2) to the starter.
4. Install the starter solenoid "S" terminal nut (1).

Tighten
Tighten the nut to 3 N·m (27 lb in).

5. Install the generator harness terminal (5) and the positive battery cable terminal (3) to the starter.
6. Install the starter solenoid terminal nut (4).

Tighten
Tighten the nut to 11 N·m (97 lb in).

7. Install the charge air cooler pump. Refer to Charge Air Cooler Coolant Pump Replacement .
8. Lower the vehicle.
9. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .