Preliminary Procedure

Remove the rear door upper extension trim panel. Refer to Upper Extension Trim Panel Replacement .

1

Rear Side Door Pull Handle Cover

Tip
Install the top portion of the pull handle cover first to ensure tabs are lined up and push the cover in firmly.

2

Rear Side Door Inside Handle Bezel Finish Cover

3

Rear Side Door Trim Panel Screw (Qty: 3)

Notice: Refer to Fastener Notice in the Preface section.

Tighten
6 N·m (18 lb in)

4

Rear Side Door Locking Rod Knob Assembly

Procedure

1. Ensure the locking rod is in the unlocked position.
2. Use a flat-bladed tool to disengage the detent tab and then remove the knob by pulling upward.
3. When re-installing, push the knob down until the detent tab touches the locking rod opening cover.
4. Push the detent tab into the lock knob to locking rod.

5

Rear Side Door Trim Panel Retainer (Qty: 9)

6

Rear Side Door Trim Panel Assembly

Procedure

1. Use a door trim pad removal tool, or equivalent, at each of the 9 retainer locations to aid in the removal of the trim panel.
2. Disengage the door lock cable.
3. Disconnect the electrical connector.